KT-300S 8 zones Hot Runner Plastic Injection Temperature Controller Compatible with DME, Yudo, Athena, Tinko
-
Payment
-
Origin
China Mainland
-
Minimum Order
1
-
Packing
Pieces
- Contact Now Start Order
- Description
Product Detail
Hot Runner Plastic Injection Temperature Controller Compatible with Dme, Yudo, Athena
KT-300S Series hot runner temperature controller is single point control. The controller is assembled with single point temperature control cards. Each card only controls the temperature of one hot point. The display of control card can show preset temperature, actual temperature and alarm, and you may set temperature parameters via the display.
8 zones
Features:
1. Inserted structure, easy to replace and repair.
2. Real time cool-end compensation, when turn on, display real temperature of the environment.
3. Accuracy: ±0.1?
4. Heater and THERMOCOUPLE fault alarm
5. High voltage alarm
6. Three modes: automatic mode, manual mode and standby mode
7. Two output mode: PID and PIDD
8. Two types of THERMOCOUPLE: J and K
9. TRIAC and RALEY series connection, double protection.
10. Self testing when turn on.
Error code and solutions
Fault | Display | Solutions |
Thermocouple breakage | tC oPEn display tC alternately with oPEn | Test the thermocouple with ohmmeter |
Thermocouple pinched | tC SHrt display tC alternately with SHrt | Find where the thermocouple is pinched |
Thermocpuple inverted | tC rEu display tC alternately with rEu | Check the thermocouple |
Thermocouple and heater swapped | tC bAd display tC alternately with bAd | Check the thermocoule and heater |
Scr breakage | Scr bAd display scr alternately with bAd | Test the Scr with ohmmeter |
The voltage is error | HIGH voL display HIGH alternately with voL | Check the the input voltage in cabinet |
Heater breakage | HEAt oPEn display HEAt alternately with oPEn | Test the heater with ohmmeter |
Heater pinched | out SHrt display out alternately with SHrt | Find where the heater is pinched |
Fuse breakage | F1-2 brk display F1or2 alternately with brk | Replace the fuse F1 or F2 |
Order please tell
1. circuit diagram(choose from A/B/C/D)
2. Wiring Diagram
5pins connector:
16pins connector:
24pins connector:
- KT-600D 2 zones Hot Runner Touch Screen Pid Temperature Controller for Plastic Injection 1 Pieces / (Min. Order)
- KT-600D 12 Zone Dual Hot Runner Control with OEM Service 1 Pieces / (Min. Order)
- KT-300D 2 zones OEM CE Double Point Control Hot Runner Temperature controller for Plastic Injection 1 Pieces / (Min. Order)
- KT-300D 24 Points CE One Card Control Two Zones Hot Runner Plastic Injection Temperature Controller 1 Pieces / (Min. Order)
- KT-300S 6 Point PID Hot Runner System Temperature Controllers for Plastic Injection Molding 1 Pieces / (Min. Order)
- KT-300S 4 zones Temperature controller for Hot Runner Injection Molding 1 Pieces / (Min. Order)