KT-300S 6 Point PID Hot Runner System Temperature Controllers for Plastic Injection Molding

Product Detail

6 point AST PID Hot Runner System Temperature Controllers For Plastic Injection Molding

KT-300S Series, one card control one hot point, a universal series of hot runner temperature controllers, are compatible with many brands in the world, such as DME, MOLDMASTERS, INCOE, HUSKY and so on.

 





1. FUZZY PIDD control technology and can automatically adapt to any heating mold in case of no tuning PID parameter so it increase working efficiency greatly.
2. Thermocouple protection function enables the controller to identify heating wire and thermocouple automatically so as to avoid the damage to thermocouple arising from wrong input of inductor
3. In case of there is short circuit between heating wire and load, heating wire output short circuit protection function enables the controller to close output automatically so as to avoid the damage to hot runner system and controller
4. Automatic environment linear compensation ensures higher precision of temperature value
5. Thermocouple automatic cool-end compensation avoids relative error due to change of environment temperature
6. Monitoring inductor error
7. Creepage detection circuit
8. Deviation alarms
9. Manual power output mode
10. Software locking
11. Display errors completely to help you find failure reason easily.




Power input voltage	AC185V-245V, 50/60Hz
One zone load	16A, 3600W
Output type	PWM/SSR
Temperature sensor wire type	J/K
Temperature control range	50?~550?
Temperature stability	±0. 5%
Temperature control type	PIDD / PID
Internal measuring loop automatic ambient temperature compensation	YES
Voltage input protection function	YES
Heating wire protection function	YES
Soft-start avoids mold leakage arising from moisture	YES




Order please tell
1. circuit diagram (choose from A/B/C/D)









2. Wiring Diagram
16pins connector:



24pins connector:



Factory